Nail Primer Fung Off Cuticle Oil Acrylic System Support Items MSDS Request Form Salon Products Home

MSDS Nail Polymer (Nail Powder)

Material Safety Data Sheet

U.S. Department of Labor

May be used to comply with

Occupational Safety and Health Administration

OSHA's Hazard Communication Standard,

(Non-Mandatory Form)

29 CFR 1910.1200. Standard must be

Form Approved

consulted for specific requirements.

OMB No. 1218-0072

IDENTITY (As Used on Label and List):

ORGANIC POLYMER

NAIL POLYMER (Nail powder)

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufacturer's Name:

NO LIFT NAILS INC.

Emergency Telephone Number:
(800) 535-5053

Address (Number, Street, City, State, and ZIP Code):

5301 BUSINESS DRIVE, HUNTINGTON BEACH, CA. 92649

Telephone Number for Information:
 (714) 897-0070

 

Date Prepared:
 02-01-2001

 

Signature of Preparer (optional)
 

Section II - Hazard Ingredients/Identity Information

Hazardous Components (Specific Chemical Identity; Common Name(s))

Poly Ethyl Methacrylate

OSHA PEL

15mg/ m3

ACGIH TLV

10mg/ m3

Other Limits
Recommended N/A

%(optional)

 (list here)

 

 

 
 

Section III - Physical/Chemical Characteristics

Boiling Point

N/A

 

Specific Gravity (H2O = 1)
 

1.11-1.14

Vapor Pressure (mm Hg.)

N/A

Melting Point

580 degrees F
 

Vapor Density (AIR = 1)

N/A

Evaporation Rate
(Butyl Acetate = 1)

N/A
 

Solubility in Water:
 Insoluble

Appearance and Odor: Fine white powder.
 

Section IV - Fire and Explosion Hazard Data

Flash Point (Method Used): 580 deg F

Flammable Limits:

N/A

LEL
 N/A

UEL
 N/A

Extinguishing Media:
 Water, carbon dioxide, dry chemical.

Special Fire Fighting Procedures:

N/A

Unusual Fire and Explosion Hazards:

N/A

Section V - Reactivity Data

Stability

Stable

Unstable

 

Conditions to Avoid:
Heating above 464 deg F

 

Stable

Yes

 

 
 

Incompatibility (Materials to Avoid): Strong oxidizing agents.
 

Hazardous Decomposition or Byproducts: methacrylate monomers
 

Hazardous
Polymerization

Will not occur

 

Conditions to Avoid N/A
 

Section VI - Health Hazard Data

Route(s) of Entry:

Inhalation? Dust may cause irritation of the nose, throat, and lungs.

Skin? May cause allergic skin reaction.

Ingestion? Can irritate respiratory system.
 

Health Hazards (Acute and Chronic)

 
 

Carcinogenicity:

NONE

NTP?

N/A

IA

RC Monographs?

OSHA Regulated?
 N/A

 
 

Signs and Symptoms of Exposure:
 

Medical Conditions Generally Aggravated by Exposure: N/A

Emergency and First Aid Procedures:
Eye Contact- Flush with water for 15 minutes, including under eyelids. Get medical attention if irritation persists.

 Skin Contact- Wash with soap and water.

Inhalation – Remove to fresh air. Get medical attention if discomfort persists.

Ingestion –  Rinse mouth out with water. Get medical attention if amount was large.

Section VII - Precautions for Safe Handling and Use

Steps to Be Taken in Case Material is Released or Spilled:
 Product is slippery. Spills should be promptly swept up.

Waste Disposal Method: May be disposed in landfill.

Precautions to Be taken in Handling and Storing:

Other Precautions:
 

Section VIII - Control Measures

Respiratory Protection (Specify Type):
USE WITH ADEQUATE VENTILATION.

Ventilation:

Local Exhaust:

Special:
 

 

Mechanical (General):

Other:
 

Protective Gloves:

N/A

Eye Protection:
 Use eye protection.

Other Protective Clothing or Equipment:
N/A

Work/Hygienic Practices: Use and store in a well ventilated area. Close container after each use. Keep away from heat, sparks and flames. Wash with soap and water after handling product. FOR SALON USE ONLY BY A LICENSED PROFESSIONAL. KEEP OUT OF REACH OF CHILDREN!

Page 2

* U.S.G.P.O.: 1986 - 491 - 529/45775

Back to Top


NO LIFT NAILS

5301 Business Drive
Huntington Beach, CA 92649

(800) 779-NAIL (6245)
(714) 897-0070 · Fax: (714) 897-0409
noliftnail@aol.com